Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Swampscott, MA

Garage Door Roller Replacement in Swampscott, MA

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. Typical cost $150-$350.

When your door needs garage door roller replacement, you want it done safely and right the first time. Typical jobs in Swampscott, MA cost $150-$350, and you approve the price first. Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Signs you need garage door roller replacement

  • Grinding, squealing or rumbling as the door moves
  • The door shakes or jerks in the track
  • Cracked, chipped or wobbly rollers
  • Rollers that no longer spin freely

What usually causes it

  • Worn-out bearings in steel rollers
  • Cracked builder-grade plastic rollers
  • Rust or dust packed into the bearings

Before the technician arrives

  • Watch the rollers while the door moves. They should roll, not slide.
  • Look for cracked plastic wheels or wobbling stems.
  • Leave the bottom rollers to a technician. They sit in brackets that hold cable tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle garage door roller replacement

  1. Inspect every roller, hinge and track section
  2. Replace rollers one hinge at a time, with sealed nylon rollers for a quieter door
  3. Replace the bottom rollers safely with tension controlled
  4. Lubricate hinges and bearings
  5. Test for smooth, quiet travel

Garage Door Roller Replacement cost in Swampscott, MA

$150-$350Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Garage Door Roller Replacement in Swampscott, MA

With large seasonal temperature swings in Massachusetts, track brackets and hinge screws work loose over time, and a loose track is the most common reason a door rubs, binds or comes off its rollers.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Our garage door roller replacement service covers Swampscott (ZIP code 01907) and nearby towns including Lynn (1.7 mi), Nahant (3.1 mi), South Peabody (3.1 mi) and Salem (3.6 mi). Call (833) 435-8883 to book a visit in Swampscott.

Garage Door Roller Replacement: frequently asked questions

How much does garage door roller replacement cost in Swampscott, MA?

Garage Door Roller Replacement typically costs $150-$350 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do garage door roller replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is garage door roller replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Massachusetts or Swampscott requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Swampscott, MA

Overhead Door Remote & Keypad Programming

Overhead Door-brand openers come from the same company as Genie, the Overhead Door Corporation.

Typical $50-$150

Wayne Dalton Off-Track Garage Door Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $175-$450

Marantec Smart Garage Door Opener Setup

Marantec is a German manufacturer of residential and commercial door openers.

Typical $100-$900

Windsor Door Garage Door Panel Replacement

Dented, cracked or rusted sections replaced or repaired to match your door.

Typical $300-$900

Opener Gear & Sprocket Replacement

Stripped drive gears replaced so the motor moves the door again.

Typical $125-$275

Allstar Garage Door Opener Repair

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $125-$350

Wall-Mount (Jackshaft) Opener Installation

Side-mounted openers that free up ceiling space and run quietly.

Typical $700-$1,400

Raynor Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

Wayne Dalton Garage Door Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$450

Garaga Garage Door Cable Repair

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $150-$350

Wayne Dalton Garage Door Installation

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $1,200-$4,500

Richards-Wilcox Garage Door Track Repair

Bent, loose or misaligned tracks straightened, realigned or replaced.

Typical $150-$400

Garage door stuck, noisy or broken?

Talk to a garage door technician in Swampscott, MA now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote